Cybrotech GSM-1 Manual do Utilizador

GGSSMM--11 UUsseerr MMaannuuaall rev. 1.10 applies to GSM-1 v3.0, v3.1 and v3.2 use CyPro 2.6.0 or later

IInnppuutt//oouuttppuutt vvaarriiaabblleess IInnppuutt//oouuttppuutt gsm_ix00..gsm_ix03 - digital inputs, 0-off, 1-on gsm_iw00..gsm_iw03 - analog

BBaassiicc ffuunnccttiioonnss SSMMSS rreeaadd//wwrriittee SMS function provides reading and writing CyBro variables. Read commands are given as:

The number of decimal places can be specified with :<d>, where d is a single digit number. Integer variables are divided by 10 for each decimal

WWoorrkkiinngg wwiitthh ppllcc pprrooggrraamm Note: this section applies to GSM-1 v3.1 only. CyBro program has complete control on voice calls a

WWiirriinngg sscchheemmaattiiccss DDiiggiittaall iinnppuuttss,, 2244VV oouuttppuutt OOuuttppuutt uussiinngg 223300VV ccoonnttaaccttoorr O

TTeecchhnniiccaall ssppeecciiffiiccaattiioonnss GSM module three-band 900/1800/1900MHz GPRS class mobile station class B Antenna internal or ext

VVeerrssiioonnss aanndd uuppggrraaddee Released versions: hardware code firmware version cypro version applicable demo GSM-1 v1.1 v3.0 v2.5.6 and

IInnddeexx Index ...

OOvveerrvviieeww GSM-1 is GSM/GPRS module for CyBro-2. Basic functions are: SMS - read and write CyBro variables - send SMS when a variable is set

QQuuiicckk sseettuupp 11.. IInnsseerrtt SSIIMM Open front cover and insert SIM in card holder. 22.. EEddiitt ccoonnffiigguurraattiioonn ffi

After transfer is complete, module will reset automatically. Minute or two later, it will connect to network, and both GSM and GPRS LEDs will be gr

- Remember CyBro IP address and port number, and close CyBroPushServer (don't skip this). - Start CyPro, open GsmIniDemo.cyp. - Configure com

CCoonnnneeccttiioonn ooppttiioonnss 1. PC-CyBro using VPN SIM cards 2. CyBro-CyBro using VPN SIM cards (UDP broadcast support is required) N

CCoonnffiigguurraattiioonn DDeessccrriippttiioonn GSM-1 is configured by sending configuration ini file. Use text editor to edit, and GsmLoader to

AAllaarrmm ffuunnccttiioonn [SMSAlarmTrigger] 1024 1025 [SMSAlarmText] Alarm: fire in cellar! CO=%co_measured:1% Alarm: valve %valve is broken! Pr